Posted By |
Discussion Topic:
Clutch Replacement
|
|
LarryK |
02-07-2015 @ 6:09 AM
|
|
|
New Member
Posts: 105
Joined: Aug 2012
|
I am planning to replace the clutch in my 1939 Deluxe Tudor. I have read in the Forum that the spring force exerted by the pressure plate should be relieved before unbolting the pressure plate from the flywheel. There is also discussion about this in the Service Bulletins where a special spring compressor tool is described and illustrated for this purpose. Lacking such a tool, how is the pressure relieved? Is there a way to block the release levers and compress the springs? If one is careful to maintain an even load on the bolts attaching the assembly to the flywheel and avoid distortion, is the load relief necessary? Thanks.
Larry
|
TomO |
02-07-2015 @ 7:38 AM
|
|
|
Senior
Posts: 7250
Joined: Oct 2009
|
I use wooden wedges. There is no need for a special tool. It is not necessary to do this when removing the pressure plate, just when installing it. When you remove the plate, turn each bolt 2 turns and then move on to the next until all pressure is removed from the disc.
Tom
|
39 Ken |
02-08-2015 @ 6:03 AM
|
|
|
Member
Posts: 380
Joined: Oct 2009
|
Larry, I would send your old clutch out to Ft. Wayne clutch in Indiana. They will rebuild to original specs or to your specs if different. Don't buy a new clutch as the are all made in china and are inferior to a proper rebuild.
|
LarryK |
02-09-2015 @ 6:38 AM
|
|
|
New Member
Posts: 105
Joined: Aug 2012
|
Thanks Ken, Tom
Larry
|