Posted By |
Discussion Topic:
wire contact pins
-- page:
1
2
|
|
1937sedandelivery |
07-09-2017 @ 12:48 AM
|
|
|
Senior
Posts: 501
Joined: Jul 2014
|
Thanks Tom. I have never used Rhode Island wiring but will look them up. My plans are to restore as much wiring as possible. I have purchased some NOS wiring assemblies on EBAY and it has worked out pretty good so far. gregg
|
TomO |
07-06-2017 @ 6:19 AM
|
|
|
Senior
Posts: 7256
Joined: Oct 2009
|
Rhode Island wiring does indeed sell tail light bucket wires for the 1937 Sedan Delivery.
Tom
|
flatheadfan |
07-06-2017 @ 1:05 AM
|
|
|
Member
Posts: 450
Joined: Oct 2009
|
I have used pop rivet ends with no problems for years. Tom
|
1937sedandelivery |
07-05-2017 @ 10:10 PM
|
|
|
Senior
Posts: 501
Joined: Jul 2014
|
I looked at using a rivet, but the one I have is slightly too large (the head) and would have to carefully grind it down to prevent shorting to the adjacent pin. So, I went back to trying to use the original contact pin and it worked out pretty good. I sacrificed a punch and ground it down to fit snuggly in the pin. Then punched the pin until it opened up some. Also ended up mashing the crimped wire remnants. Cleaned those out as well as possible and it left enough room to solder in a new wire. All in all, the pin reuse worked out well. See attached picture. Gregg
|
woodiewagon46 |
07-05-2017 @ 5:58 PM
|
|
|
Senior
Posts: 704
Joined: Nov 2012
|
I just had another thought. There is a company called Rhode Island Wiring. They might have what you need.
|
woodiewagon46 |
07-05-2017 @ 5:49 PM
|
|
|
Senior
Posts: 704
Joined: Nov 2012
|
I can't tell you where to purchase new pins but I can tell you what I did. First I filed the pins flush and then grabbed the pin with a needle nose vise grips. I then started with a small drill and worked my way up to a size that the wire would fit into and then soldered it. Take your time because the drill will tend to bind, but it will eventually cut thru the crimped wire and part of the crimp itself.
|
1937sedandelivery |
07-05-2017 @ 4:11 PM
|
|
|
Senior
Posts: 501
Joined: Jul 2014
|
I bought a couple wiring kits from Drakes and they are terrible, cheap Chinese vinyl coated junk, very disappointing. Haven't looked at Mac's. Thanks, Gregg
|
carcrazy |
07-05-2017 @ 3:52 PM
|
|
|
Senior
Posts: 1667
Joined: Oct 2009
|
You can also purchase new taillight wiring sockets or socket repair kits from MAC's Auto Parts.
|
1937sedandelivery |
07-05-2017 @ 3:00 PM
|
|
|
Senior
Posts: 501
Joined: Jul 2014
|
Very interesting, I happen to have some small rivets from a headlamp bucket rebuild kit for a 37. I will give it a try and report back. Thanks!! gregg
|
nelsb01 |
07-05-2017 @ 2:31 PM
|
|
|
Senior
Posts: 983
Joined: Oct 2009
|
Try hollow ended rivets. There are some small ones out there. And, if the connection end is too flat, add some solder on to it. Hope this helps.
|