Posted By |
Discussion Topic:
40 oil levelsbvbvbv
-- page:
1
2
3
|
|
tweetsmith01 |
05-17-2021 @ 5:15 PM
|
|
|
New Member
Posts: 105
Joined: Sep 2019
|
kube, the oil level in a 40 with oil filter takes 5 quts was their a different dipstick or just mark mine at net location thanks for any syggestions
|
kubes40 |
05-18-2021 @ 6:59 AM
|
|
|
Senior
Posts: 3394
Joined: Oct 2009
|
One dipstick for the 85 / 100 HP engines. There's a good chance yours has been replaced through the past years with an incorrect stick. I'd suggest you change the oil, add you five quarts and let it settle. Then, mark the stick. Do you have the dense felt pad (dust seal) directly below the stick washer? That is nearly always missing.
Mike "Kube" Kubarth
|
tweetsmith01 |
05-18-2021 @ 5:51 PM
|
|
|
New Member
Posts: 105
Joined: Sep 2019
|
kube, my oil stick shows full with 4 qts but i just connected the oil d filter that was disconnect so ill just remark the stick and no i do not have a felt seal any available anywhere that you would know thank you
|
kubes40 |
05-19-2021 @ 4:58 AM
|
|
|
Senior
Posts: 3394
Joined: Oct 2009
|
check your private message
Mike "Kube" Kubarth
|
Hillfarmer |
05-21-2021 @ 8:23 AM
|
|
|
Member
Posts: 12
Joined: May 2021
|
Is in normal for the oil filter to drain back into the crankcase when the engine is off on a 1940?
|
TomO |
05-21-2021 @ 8:29 AM
|
|
|
Senior
Posts: 7250
Joined: Oct 2009
|
It is not normal for the oil in the filter to drain back into the crankcase when the engine is off.
Tom
|
tweetsmith01 |
05-21-2021 @ 6:42 PM
|
|
|
New Member
Posts: 105
Joined: Sep 2019
|
hi tom , i read your post and am wondering what would stop the oil filter from draining back to crankase
|
TomO |
05-22-2021 @ 7:34 AM
|
|
|
Senior
Posts: 7250
Joined: Oct 2009
|
The filter outlet is higher than the block outlet that feeds the inlet. See drawing.
Tom
|
tweetsmith01 |
05-22-2021 @ 12:05 PM
|
|
|
New Member
Posts: 105
Joined: Sep 2019
|
tom im trying to learn how this works just connected it the feed to the filter comes from rear of block to about 3in up on the filter canister and the return from the filter goes out the bottom into side of oil pan do i have this filter connected correctly
|
kubes40 |
05-23-2021 @ 6:26 AM
|
|
|
Senior
Posts: 3394
Joined: Oct 2009
|
Tweets, much of the oil, but not all, will drain back in to the engine. You do have it correctly plumbed.
Mike "Kube" Kubarth
|