Posted By |
Discussion Topic:
trans shaft pins
-- page:
1
2
|
|
4ford |
02-21-2015 @ 2:59 PM
|
|
|
Member
Posts: 88
Joined: Oct 2010
|
trying to get the shifter levers of and replace seals. is there an easy way to remove them?? need to remove the pins
|
carcrazy |
02-21-2015 @ 7:32 PM
|
|
|
Senior
Posts: 1678
Joined: Oct 2009
|
This is a job best entrusted to a good local machine shop.
|
JM |
02-22-2015 @ 6:09 AM
|
|
|
Senior
Posts: 823
Joined: Oct 2009
|
Your post here + picture gives a better explanation of what you are trying to do than what you posted on Fordbarn. I was not sure which shift rods and pins you were talking about on FB. Anyway, I believe Mac Van Pelt gave you some good advice over on FB.
John
|
4ford |
02-22-2015 @ 6:38 AM
|
|
|
Member
Posts: 88
Joined: Oct 2010
|
thanks the pics o fb would not work. so straight or tapered ?
|
TomO |
02-23-2015 @ 7:39 AM
|
|
|
Senior
Posts: 7258
Joined: Oct 2009
|
The pins are straight and you can get them at Van Pelts Sales. Be sure to support the shift arm when trying to drive out the pins. This is done best as a 2 man job. One man holds the side cover so that the shift lever is supported and the pin has a place to go. Grind or file the peened over ends of the pin so the pin can be driven through, then drill an 1/8" hole in the center of the pin to relieve some of the strain.
Tom
|
JM |
02-23-2015 @ 11:00 AM
|
|
|
Senior
Posts: 823
Joined: Oct 2009
|
Deleted duplicate post
This message was edited by JM on 2-23-15 @ 11:02 AM
|
JM |
04-07-2015 @ 12:22 PM
|
|
|
Senior
Posts: 823
Joined: Oct 2009
|
....
This message was edited by JM on 4-9-15 @ 9:36 AM
|
JM |
04-07-2015 @ 2:33 PM
|
|
|
Senior
Posts: 823
Joined: Oct 2009
|
....
This message was edited by JM on 4-9-15 @ 9:35 AM
|
JM |
04-07-2015 @ 5:37 PM
|
|
|
Senior
Posts: 823
Joined: Oct 2009
|
.....
This message was edited by JM on 4-9-15 @ 7:22 AM
|
JM |
04-09-2015 @ 7:19 AM
|
|
|
Senior
Posts: 823
Joined: Oct 2009
|
...
This message was edited by JM on 4-9-15 @ 7:20 AM
|