Posted By |
Discussion Topic:
Is There an Exhaust System That Fits
|
|
EWATERS |
01-10-2010 @ 4:26 PM
|
|
|
Member
Posts: 65
Joined: Dec 2009
|
Have you (or anyone) tried "Classic Exhaust" in Geneva, Ohio? I ordered a set for my 1950 Ford with a 6-cylinder engine in June of 2009. I have not yet reached the point of installing it; I hope it works.
|
trjford8 |
01-05-2010 @ 8:17 PM
|
|
|
Senior
Posts: 4219
Joined: Oct 2009
|
You might try Waldren Exhaust; www.waldrenexhaust.com. I have found that most prefab exhaust stuff always needs some work. It is not just a bolt-on and go product. I agree with Bob and would go to a good independant muffler shop and have it custom made.
|
supereal |
01-05-2010 @ 8:05 AM
|
|
|
Senior
Posts: 6819
Joined: Oct 2009
|
Most, if not all, prefab exhaust systems require substantial modifications to fit properly. We have all systems made up at a very good local shop, including some in stainless steel. It is quicker, and usually less expensive, than ordering a system and expecting it to fit out of the box. Look around for a good independent shop, as the franchised places usually seem to think that a "bender" is something you do at a bar!
|
MOXIE |
01-04-2010 @ 5:46 PM
|
|
|
New Member
Posts: 102
Joined: Oct 2009
|
Is there anyone reproducing the complete exhaust system for a 1935 V8 car that will actually fit without reworking. I installed a system in a 1934 car and had to use the torch to bend pipes to make them fit, esp. the cross over pipe.
|