Posted By |
Discussion Topic:
37 column drop on/off lever installation
|
|
Kens 36 |
06-22-2020 @ 8:24 AM
|
|
|
Member
Posts: 350
Joined: Oct 2009
|
Gregg, I suspect Tom is referring to an article in the September/October 2002 V-8 Times. The VERY best way to research the V-8 Times is to buy the $19.95 V-8 Times flash drive, available in the Online Store. Ken
|
1937sedandelivery |
06-22-2020 @ 7:34 AM
|
|
|
Senior
Posts: 501
Joined: Jul 2014
|
Thanks guys. I do have another column drop that is in pretty poor shape. Will see what i can harvest and what makes sense. I will look for that article. gregg
|
TomO |
06-22-2020 @ 6:57 AM
|
|
|
Senior
Posts: 7256
Joined: Oct 2009
|
Gregg, there was a good article on repairing the column drop in the V-8 Times a few years ago. Download the searchable index to find the issue that had this information and if you don't have it, the issue can likely be purchased from The Early Ford V-8 Foundation Museum.
Tom
|
37RAGTOPMAN |
06-22-2020 @ 5:55 AM
|
|
|
Senior
Posts: 1963
Joined: Oct 2009
|
hi 37Sedandelivery I thought you were talking about the electric switch part, not the switch lever and operating pin being loose or stripped out, I guess you have to use a little force pressing together looks like you are missing the chrome end cap, after studying the photo, looks like you need to disassemble the whole switch to correctly install the parts you have, this may be the easiest way, so what you put together does not come apart, do you have a spare switch for parts.? maybe someone else has a better answer, hope this helps 37Ragtopman
This message was edited by 37RAGTOPMAN on 6-22-20 @ 6:08 AM
|
1937sedandelivery |
06-21-2020 @ 7:30 PM
|
|
|
Senior
Posts: 501
Joined: Jul 2014
|
Two jpeg photos attached
|
37RAGTOPMAN |
06-21-2020 @ 9:40 AM
|
|
|
Senior
Posts: 1963
Joined: Oct 2009
|
Gregg as far as I can remember is should fit together,with no problems, ignition switch is held together with screws,with 2 studs sticking out the back for attaching the wires, I do not remember using force to assembly the switch, just a little tricky if you are using reproduction parts I think that is the problem, if you could post a photo it might help my 2 cents 37Ragtopman
|
1937sedandelivery |
06-21-2020 @ 9:01 AM
|
|
|
Senior
Posts: 501
Joined: Jul 2014
|
Hello, I am rebuilding my 37 column drop. It is all back together except for the pin that actuates the ignition switch contacts and the on/off lever itself. Are both of these press fit? I should locate each item slightly above its respective hole and lightly tap into place? I tried this with the on/off lever and it didn't want to readily seat in the hole. I should apply more force? Last thing i want to do is bugger something up. Thanks, gregg
|