Posted By |
Discussion Topic:
'34 winshield frame
|
|
jcf |
01-02-2020 @ 11:24 AM
|
|
|
Member
Posts: 12
Joined: Jan 2020
|
I am in the process of replacing the windshield glass and the rubber seal around the frame. How do I get the seal in the frame grove and still lay flat against the against the frame?
|
40 Coupe |
01-03-2020 @ 4:17 AM
|
|
|
Senior
Posts: 1678
Joined: Oct 2009
|
If you did not clean out all of the old rubber from the previous seal you will not get the new seal in properly. There is a small groove at the bottom of the seal recess that also needs to be cleaned on the outer seal. Are you questioning the inner glass to frame seal?
This message was edited by 40 Coupe on 1-3-20 @ 4:19 AM
|
1934 Ford |
01-04-2020 @ 12:06 PM
|
|
|
Senior
Posts: 573
Joined: Oct 2009
|
Take the windshield off and do it on a table, it's much easier. 1934 Ford's since 1972
This message was edited by 1934 Ford on 1-4-20 @ 12:07 PM
|
jcf |
01-04-2020 @ 3:59 PM
|
|
|
Member
Posts: 12
Joined: Jan 2020
|
thanks for your responses. I looked at the windshield frame closer than before, the small groove in the frame, at the bottom of the seal recess, does have more surface rust. So I am going to figure out a way to soak the frame, 2 pieces, in some Evapo Rust. That is probably the only way to clean that groove.
|