Posted By |
Discussion Topic:
'47 Merc Front Floor Mat
-- page:
1
2
|
|
len47merc |
04-03-2014 @ 4:31 PM
|
|
|
Senior
Posts: 1165
Joined: Oct 2013
|
Now that the motor is out (thanks to all for the great advice) why not (right?) go ahead and pull the transmission to clean it as well as change the original seeping/leaking front, rear (primary leak) and side cover selector (shift arms) gaskets and seals, plus a new release bearing & u-joint. The only problem - the same one - is preservation of the original and now very brittle Mercury specific front floor mat. Any experience out there with (efficiently) pulling the trans without removing the entire front floor pan is appreciated. Intuitively it looks to be possible but quite tedious (drop radius rod and mouting bracket for same, very limited/tight access to trans and u-joint 'cup' nuts/bolts, etc.). Am leaning toward changing the front and side cover selector seals and the release bearing only and dealing with the rear leak and likely-to-be somewhat worn splines of the original u-joint. With the motor out I hate not to take advantage of the opportunity to (efficiently) address these items as well.
Steve
|
ford38v8 |
04-03-2014 @ 5:06 PM
|
|
|
Senior
Posts: 2758
Joined: Oct 2009
|
Steve, the Rouge Class on the Ford V8 Club Concourse is intended to encourage the preservation of original examples of the Ford products. Any replacement or rebuilding of major elements of the car will result in detracting from that goal, reflected by the possible passing over of that area of the car for purposes of the Rouge Award. That said, to answer your question regarding transmission removal, it normally comes out the top, with floorboards removed. I imagine it would also come out by moving it forward while the engine is out, but can't be positive on that.
Alan
|
len47merc |
04-03-2014 @ 5:59 PM
|
|
|
Senior
Posts: 1165
Joined: Oct 2013
|
Thanks Alan - at this point my plan is to forgo the chassis/engine element and focus on the body & completely original interior, hence the need to preserve the front floor mat. The engine came out to change the front and rear seals. Prior to its removal the oil pan and timing cover were removed, cleaned, primed and painted (the correct colors) in my then ignorance/misinterpretation of Rouge class intent. Though I was advised to purchase a used, roached-out timing cover and pan and install them for judging, while continuing the in-car attempt at replacement of the rear seal the oil pump was pulled to facilitate access to the top rope seal carrier and chunks of caked-up non-detergent oil, likely compounded by the decades of idled time without running, came out with it. A concern was that some of the debris may have fallen into the oil channel for the mains which a look with a small dental mirror and flashlight confirmed. Ouch. Thus the now 38K original mile motor that I have put 1,500 miles of joyous drive time since bringing it back to life this past November had to be pulled. On top of this, while cleaning the years of gunk off of the motor which completely obscured the original Mercury blue color it was found the driver's side head was not original in design or color which became a huge problem for Rouge class according to efv8 technical advisers. Should I have chosen only to source and install another original 59 A-B head it would not have had the same patina as the balance of the motor and would have stood out (again, this from efv8 tech advisers), so I am basically out of luck now on this element of the Rouge class. Best laid plans the moral of the story here. Fundamentally this is now why I am now so focused on preserving the original front floor mat and finding a way to remove the trans without disturbing the trans cover and mat. Apologies for the dissertation - lessons learned here may help others. Cheers
Steve
|
ford38v8 |
04-03-2014 @ 8:36 PM
|
|
|
Senior
Posts: 2758
Joined: Oct 2009
|
Steve, All is not lost in your quest for a Rouge award. You are now aware, I'm sure, that there are three separate areas of Rouge Judging for which the award may be given without reference to the other areas that may not qualify. Your car may now qualify for Interior, and perhaps Exterior? The mismatch head having disqualified Engine/Chassis can now prove to be a benefit in your pleasure in driving your original Mercury, something that must be emphasized as why most of us are here in the first place!
Alan
|