Posted By |
Discussion Topic:
CANNOT OPEN TRUNK HELP
|
|
TomO |
04-21-2014 @ 7:04 AM
|
|
|
Senior
Posts: 7264
Joined: Oct 2009
|
You will either have to look for a Ford handle and lock or buy a new reproduction. The less expensive way is a new reproduction. Chrome plating a Ford handle will cost about the same as the reproduction handle. C & G has the reproduction handles.
Tom
|
joe b |
04-20-2014 @ 7:40 PM
|
|
|
Member
Posts: 389
Joined: Oct 2010
|
Jessers was unable to do a lock for my '41 which has a re-pro handle.
|
TomO |
04-20-2014 @ 7:38 AM
|
|
|
Senior
Posts: 7264
Joined: Oct 2009
|
Before looking for a new cylinder, check your handle to make sure that it is not a reproduction. I am not sure that the original locks will fit in all of the reproduction handles. The original should have a Ford Part number cast into it. You can try Jesser's Classic Keys for a lock. They show up on E-Bay regularly.
Tom
|
murphy1936 |
04-19-2014 @ 9:43 PM
|
|
|
New Member
Posts: 191
Joined: Nov 2013
|
Trunk lock resolved, after trying all recommendations the locksmith had his day and, presto out came the lock cylinder. Junk cylinder cannot be used, so now have to hunt down cylinder for trunk lock on 1941 super deluxe coupe
Super Deluxe 41
|
40 Coupe |
03-29-2014 @ 5:41 AM
|
|
|
Senior
Posts: 1685
Joined: Oct 2009
|
Turn the key about 45 degrees and then depress the small retaining pin on the top of the cylinder then without moving the key get the cylinder back into it's hole, all the way in.
|
murphy1936 |
03-28-2014 @ 9:20 PM
|
|
|
New Member
Posts: 191
Joined: Nov 2013
|
Just recent problem. Went to unlock trunk and entire key cylinder came out so I put it back in so I could unlock trunk. WONT UNLOCK. IS THERE A WAY TO GET KEY CYLINDER OUT AGAIN? This is on 1941super deluxe. Last resort a locksmith. John
Super Deluxe 41
|