Posted By |
Discussion Topic:
21A-4271 stud and washer for rear track bar
|
|
mhartley |
02-02-2011 @ 5:10 PM
|
|
|
Member
Posts: 4
Joined: May 2010
|
Thanks.. I do know the ID of the bushing is for a 5/8" shouldered bolt and using the bolt from the opposite end will help give me an idea as to the length. Mike Hartley Danville, Indiana
|
supereal |
02-02-2011 @ 2:16 PM
|
|
|
Senior
Posts: 6819
Joined: Oct 2009
|
Mike: Can't find the specs, but the piece is shown on page 130 of the green book. It says that the locknut on the bushing side is 1/2" - 20, and the locking pin is 3/16" X 1 1/4". By measuring the bushings, you may be able to determine the diameter and the length required. You could also try Chassis Engineering, as they once measured the track ("panhard") bar on my '47 so they could make them. Their site is www.chassisengineeringinc.com
|
mhartley |
02-02-2011 @ 11:55 AM
|
|
|
Member
Posts: 4
Joined: May 2010
|
Hi folks, I was wondering if anyone would have any specs, detailed photos, etc for pn 21A-4271 that they would not mind sharing? I plan to make one out of stainless steel so I can mount the original rear track bar on my 46 Ford. Any help would be appreciated. Thanks, Mike Hartley Danville, Indiana
|