Posted By |
Discussion Topic:
Testing Gauges 1941 Ford DeLuxe
|
|
wilsonsk |
08-07-2022 @ 12:06 PM
|
|
|
Member
Posts: 57
Joined: May 2022
|
I bought a NOS oil pressure gauge for my 1941 DeLuxe, the needle was broken on the one in the dash. I put in the new one but it isn’t working. How do I test the sending unit and the gauge? Thanks, Steve
|
wilsonsk |
08-07-2022 @ 12:40 PM
|
|
|
Member
Posts: 57
Joined: May 2022
|
That mystery is solved, the connection on the sender was dirty, I was testing the sender resistance when it was running, after I reconnected it it worked fine, a little over 20 idling, almost goes to 50 revving it up. Not sure how accurate the dash gauges are but its in the middle idling and almost pegged revved up, that should indicate that I have plenty and not a problem.
|
ford38v8 |
08-07-2022 @ 8:25 PM
|
|
|
Senior
Posts: 2758
Joined: Oct 2009
|
You might still have a problem. I can’t imagine oil pressure being that high on a flathead. Ideas might be mismatch sender/gauge, 12v conversion issues, or oil viscosity?
Alan
|
40cpe |
08-07-2022 @ 9:09 PM
|
|
|
Member
Posts: 472
Joined: Jan 2010
|
Are you getting those readings on cold oil, or running temp?
|
wilsonsk |
08-08-2022 @ 6:08 PM
|
|
|
Member
Posts: 57
Joined: May 2022
|
That was barely warmed up (it takes a while), I drove it about 30 miles at 55-60 today, ran a little under 190 temp, at a stop sign it went down to 10-15 (a little over the line between 0 and 20, ran at about the line between 20 and 50 at 60 mph (30-35psi?).
|
ford38v8 |
08-08-2022 @ 6:35 PM
|
|
|
Senior
Posts: 2758
Joined: Oct 2009
|
That's more like it.
Alan
|
51woodie |
08-09-2022 @ 6:50 AM
|
|
|
Senior
Posts: 510
Joined: Jan 2017
|
Regarding the comment on high oil pressure, my stock 59AB runs at 20 psi idle, and 60 psi at speed on mechanical the mechanical gauge. The dash pressure gauge shows 1/4 at idle, and just over half way at speed. I was initially using 15-40, then switched to 10-30, because I thought the pressures were too high. Changing to a lower viscosity made no difference in the pressures. Note: It is best practice to disconnect the lead to the coil when testing is done on the gauges, so there is no damage done to the coil or points.
|