Posted By |
Discussion Topic:
34 generator feed wire routing
|
|
dean333 |
08-11-2021 @ 1:24 AM
|
|
|
Member
Posts: 259
Joined: May 2012
|
Does the wire run alongside the spark plug tube or inside? Thanks!
TIM CARLIG
|
40 Coupe |
08-11-2021 @ 4:45 AM
|
|
|
Senior
Posts: 1685
Joined: Oct 2009
|
Both the generator output wire and the red wire for coil power run inside the plug conduit and exit near the front of the engine at the bottom of the conduit.
|
dean333 |
08-11-2021 @ 4:50 AM
|
|
|
Member
Posts: 259
Joined: May 2012
|
I should have fed it before the plug wires, gonna be tricky now. Thanks 40! TIM CARLIG
This message was edited by dean333 on 8-11-21 @ 4:51 AM
|
dean333 |
08-13-2021 @ 10:03 AM
|
|
|
Member
Posts: 259
Joined: May 2012
|
Had to do it twice 40coupe. First I had it exit at the front of the tube but then it was too short to reach the generator. I pulled it back out and the second time had it exit above #5 cylinder. Thanks!
TIM CARLIG
|
kubes40 |
08-13-2021 @ 11:17 AM
|
|
|
Senior
Posts: 3424
Joined: Oct 2009
|
There is a hole in the conduit for this wire IF you have the correct conduit. Mike "Kube" Kubarth
This message was edited by kubes40 on 8-13-21 @ 12:57 PM
|
sarahcecelia |
08-14-2021 @ 5:55 AM
|
|
|
Senior
Posts: 1194
Joined: Mar 2013
|
Hook apiece of fine safety wire to it; thread the other end of that safety wire through the tube until it sticks out enough to get a hold on it, and pull the wire it is attached to, through the tube. A little silicone or something similar on the car wire(s) that you want to pull through might help. Regards, Steve Lee
This message was edited by sarahcecelia on 8-14-21 @ 5:59 AM
|