Posted By |
Discussion Topic:
Sealing under the Stanless and Potmetal Trim Piece
|
|
RAK402 |
06-25-2022 @ 10:04 AM
|
|
|
Member
Posts: 438
Joined: Jul 2015
|
Thank you both for the replies. The cars is very far apart right now, so applying sealer from the inside after I re-install the stainless trim should be relatively easy. I will look into the Window Weld and Strip Caulk.
|
trjford8 |
06-25-2022 @ 6:54 AM
|
|
|
Senior
Posts: 4218
Joined: Oct 2009
|
3M still makes dum-dum and it's call strip caulk. You can probably get it from Amazon or on e-Bay. Alternatives are 3M Heavy Duty Drip check sealer (comes in a tube) or 3M Window Weld which is used to seal windshields on modern cars (comes in a roll). As Mike has advised stay away from any type of silicone sealer. When I seal the trim I put it on the back side around the clips where they stick through the metal body.
This message was edited by trjford8 on 6-25-22 @ 6:58 AM
|
kubes40 |
06-25-2022 @ 6:29 AM
|
|
|
Senior
Posts: 3406
Joined: Oct 2009
|
After the trim was installed, Ford placed a small amount of body sealer on the back side, prior to upholstery. If that's not an option for you, I don't believe you have any good alternatives. Keep silicone sealer away from your paint!
Mike "Kube" Kubarth
|
RAK402 |
06-24-2022 @ 4:16 PM
|
|
|
Member
Posts: 438
Joined: Jul 2015
|
Should I apply some sort of sealant to the holes in the body, doors, etc. where the stainless steel trim pieces clip on, the hood ornament/latch, trunk handle, etc. is installed? I think they used to use something called "dum dum" to do it back in the 40's (my father told me about it). I don't want water from washing the car or rain to get into the doors and ruin the panels and upholstery. This is for a 1940 Deluxe Sedan.
|