bonusbuilt1950 | -- 04-01-2012 @ 9:54 AM |
I have a factory signal switch from a 49-50 Ford car, SXTS-B. All the wires are gone from the back of the little switch. I'm hunting for a schematic, so I can solder new wires to the switch. I was wondering if anyone else has done this and kept notes as to what they did? There's nothing I've found that is that detailed. I think I have a NOS harness here that will repair it, I just need to know where what wire goes where. Any help or ideas? Barry 50 F-1
|
|
jfarrell | -- 04-01-2012 @ 11:31 AM |
I can fax you a copy of a wiring diagram from 42-50 passenger car turn indicators. If you give me a fax number I will fax it from the office tomorrow morning. Jim Farrell
|
|
bonusbuilt1950 | -- 04-01-2012 @ 2:27 PM |
You can send a fax of the schematic to 860-525-8977 and put to the attention of Mich*lle McCloskey. She'll bring it home to me. Thanks, Barry 50 F-1 This message was edited by bonusbuilt1950 on 4-1-12 @ 2:28 PM
|
|
37 Coupe | -- 04-02-2012 @ 9:45 AM |
See if this will help you. I have never seen a NOS harness that didn't have the switch attached a vice versa for the SXTS-B,but a lot of nice reproductions of the harness have been made
|
|
bonusbuilt1950 | -- 04-02-2012 @ 4:31 PM |
jfarrell and 37 Coupe- Thanks to both of you for the schematic. It's exactly what I need!! I appreciate it. Barry 50 F-1
|
|
EFV-8 Club Forum : | https://www.earlyfordv8.org/forum |
Topic: | https://www.earlyfordv8.org/forum/viewmessages.cfm?Forum=18&Topic=4512 |