| Dwall | -- 12-02-2009 @ 7:03 PM |
|
Can anyone direct me to a source of blueprints showing the rear view dimensions of the 60 HP 37/40 model?,(I need to make an adaptor plate very accurate). Thank you dwall
|
|
| trjford8 | -- 12-03-2009 @ 7:49 AM |
|
I think you may have to go to the archives in Dearborn, Michigan.It's known as the Benson Ford Research Center. You might also check with Roy Nacewicz(he advertises in the vendor section of this site)as he knows a lot about the 37 Fords. That is when the 60 was introduced. Roy's website is ;www.fordbolts.com. This message was edited by trjford8 on 12-3-09 @ 7:49 AM
|
|
| EFV-8 Club Forum : | https://www.earlyfordv8.org/forum |
| Topic: | https://www.earlyfordv8.org/forum/viewmessages.cfm?Forum=18&Topic=398 |