| shumburg | -- 02-14-2022 @ 9:40 PM |
|
Is this the correct garnish moulding for the doors on 39 Delux Convertible Coupe? If so, does anyone have one to sell? I only have this one. If it's not correct, please post a photo of what I should look for? Thanks
|
|
| 37RAGTOPMAN | -- 02-15-2022 @ 7:44 AM |
|
HI Shumburg do you have any measurements ? and close up photo's it could be the same as 37 38 FORD CABRIOLETS 78-760A 81-760A also which would give you maybe more years to choose from hope this helps 37 Ragtopman This message was edited by 37RAGTOPMAN on 2-15-22 @ 7:48 AM
|
|
| shumburg | -- 02-15-2022 @ 2:59 PM |
|
Thanks for the advice, here are additional pictures
|
|
| wmsteed | -- 02-18-2022 @ 8:21 AM |
|
I have had a considerable amount of experience with '37-39 Convertible coupes. I don't claim to be an expert on the Fords which are generally Briggs bodied, I have been involved with the restoration of several 39 Plym convertible coupes, which also had Briggs bodies. Looking at your door sill molding I would say it is correct for a Ford conv coupe. Post a picture of the inner edge of the sill where it meets the window. i want to see if it has provisions for a rubber seal that screws to the return edge, closing the gap between the sill and the window. Bill 36 5 win delx cpe
|
|
| shumburg | -- 02-24-2022 @ 7:32 PM |
|
The window contact is scr*w*d to the moulding and has a brush surface.
|
|
| EFV-8 Club Forum : | https://www.earlyfordv8.org/forum |
| Topic: | https://www.earlyfordv8.org/forum/viewmessages.cfm?Forum=18&Topic=15488 |