| gfstew | -- 08-05-2018 @ 9:43 AM |
|
I have a 1936 Ford 2 door slant back . And I found out the Dome light does not work I put the switch up and down and the light does not come on. I am having a hard time trying to remove the glass dome lens to see if it has a bulb in the socket and I can not get the glass dome light to br removed HOW can I remove the glass lens ??
|
|
| Don Rogers | -- 08-05-2018 @ 11:35 AM |
|
There is a snap ring holding the glass lens in place.
|
|
| ken ct. | -- 08-05-2018 @ 11:43 AM |
|
More of a wire clip,get under 1 end of it with an ice pick or sharp awl,will do it. ken ct This message was edited by ken ct. on 8-5-18 @ 10:59 PM
|
|
| ken ct. | -- 08-05-2018 @ 11:43 AM |
|
More of a wire clip,get under 1 end of it with an ice pick oe sharp awl,will do it. ken ct
|
|
| ken ct. | -- 08-05-2018 @ 11:43 AM |
|
More of a wire clip,get under 1 end of it with an ice pick oe sharp awl,will do it. ken ct
|
|
| lkelton4 | -- 12-28-2018 @ 6:14 PM |
|
I’m having the same issue. I did get the snap ring off. I figured out that much. Now I cannot get the glass out. It is wedged tightly. Any ideas on how to remove the dome light glass? Thanks much.
|
|
| 40 Coupe | -- 12-29-2018 @ 4:30 AM |
|
Stuck glass try a suction cup to pull it down. Slightly warm the glass with a hair dryer.
|
|
| EFV-8 Club Forum : | https://www.earlyfordv8.org/forum |
| Topic: | https://www.earlyfordv8.org/forum/viewmessages.cfm?Forum=18&Topic=12192 |