Eagleone | -- 06-20-2021 @ 4:57 PM |
Im needing to remove seat riser from my 40 pickup and wondered if its just held down with the cab mtg. bolts? I just acquired the pickup so im not familiar with it. Thanks.
|
|
trjford8 | -- 06-21-2021 @ 2:07 PM |
The metal seat riser was riveted to the floor from the factory.
|
|
alanwoodieman | -- 06-21-2021 @ 7:14 PM |
if the cab is a 40/41 the seat riser is the gas tank itself and yes it is bolted to the floor with threee bolts, gas line connection and the fuel gauge sender wire
|
|
Eagleone | -- 06-21-2021 @ 7:22 PM |
The 40 gas tank is at rear of frame.
|
|
Eagleone | -- 06-21-2021 @ 7:26 PM |
I will have to clean it up and find the rivet heads to drill them out to remove riser then for repair.Thanks for the good info.
|
|
51504bat | -- 06-22-2021 @ 5:57 AM |
'40/41 big trucks had the tank under the seat. The p/u's had the tank in the rear so a seat riser was installed in place of the under seat tank. ______________ No signature
|
|
EFV-8 Club Forum : | https://www.earlyfordv8.org/forum |
Topic: | https://www.earlyfordv8.org/forum/viewmessages.cfm?Forum=17&Topic=14939 |