sam | -- 09-08-2017 @ 9:52 AM |
Hi,I would like to know what the markings are on 1948 Merc heads. I know that fords are 59AB,thanks I'll look for your answer,Sam.
|
|
cliftford | -- 09-08-2017 @ 10:00 AM |
If it's an original engine, it would be the same 59AB.
|
|
len47merc | -- 09-08-2017 @ 4:19 PM |
Cliftford is correct. Post-war '46-'48 Mercurys were basically Fords with the Mercury trim package and employed the 59A-B engine. Mercury specific engines began to reappear in '49. Head designations are typically 59A earlier in the '46-'48 sequence and 59A-B later. Perhaps the exact cut-off date is published but I've been unable to find it. My '47 Merc was finished in Jan '47 and has its serial number matching. 59A-B in it. Steve
|
|
TomO | -- 09-10-2017 @ 8:31 AM |
The 59 AB heads appear as replacement parts in the January 1946 Chassis Parts Catalog. It was released as a replacement head for the 38-44 heads. Rusty Davis may have a date when they were used in production. Tom This message was edited by TomO on 9-10-17 @ 8:33 AM
|
|
len47merc | -- 09-10-2017 @ 9:45 AM |
Thanks Tom. My reply above came both from my notes from a phone call/discussion with Rusty Davis on this subject (and others) from early 2014 and as well page 5-3 of Chapter 5 of the 41 - 48 Ford book. Rusty indicated no specific date during my call for conversion from 59 A to 59 A-B but perhaps he did/does have that and it just never came up. 'Back then' I didn't know/think to ask the question - I was in the process of converting my mindset from restoration to Rouge preservation and was calling him at the time to confirm originality on the '47. Either that or I simply was sloppy in my note taking. Likely the former - worth a call as you suggested to Sam. Strongly suspect though given Sam's talking '48 that 59 A-B is correct unless Ford's then FIFO program allowed dated inventory to be used that far into the 3-year model period. That's good information that you've provided as well - adding it to my file. Steve
|
|
len47merc | -- 09-10-2017 @ 9:46 AM |
Edit - eliminating duplicate post. Steve This message was edited by len47merc on 9-10-17 @ 9:48 AM
|
|
sam | -- 09-17-2017 @ 8:03 AM |
Hey, To everyone who answered my post about the cylinder heads Thanks. I definitely didn't know that they were the same as the Ford markings. Thanks Again,Sam.
|
|
EFV-8 Club Forum : | https://www.earlyfordv8.org/forum |
Topic: | https://www.earlyfordv8.org/forum/viewmessages.cfm?Forum=16&Topic=11165 |