alsmith39 | -- 03-24-2016 @ 11:37 AM |
I need to know if all 40 Fords had engine Radius Rods. If so I need to know if therenis andiagram showing the rodsin their correct location.
|
|
kubes40 | -- 03-24-2016 @ 5:10 PM |
Yes, all 1940 Ford passenger cars had these rods. One end was attached through a bore in the lower - rear of the engine block. The other end was bolted to the frame. There really is no way a guy could put these in incorrectly. Attached herein is a photo depicting the forward attachment point. Hope this helps. Mike Kubarth
|
|
kubes40 | -- 03-24-2016 @ 5:13 PM |
Here's a photo depicting both ends. Mike Kubarth
|
|
alsmith39 | -- 03-25-2016 @ 1:59 AM |
Thanks for the information and photos. While removing the engine I neglected to take pictures of the rods and could not remember how they went in.
|
|
EFV-8 Club Forum : | https://www.earlyfordv8.org/forum |
Topic: | https://www.earlyfordv8.org/forum/viewmessages.cfm?Forum=14&Topic=9509 |